Gates Mectrol • Urethane Timing Belts and Pulleys 3. Urethane Timing Belts and Pulleys. Table of Contents. Broadest Range Available. Belt Selection Guide. Timing belts and pulleys — in order to handle a wide range of loads, speeds and applications at highest possible efficiencies — are made in five stock pitches. of the pulley mating with it. Any timing belt must be run with pulleys of the same pitch. A belt of one pitch cannot be used successfully with.
|Published:||19 November 2015|
|PDF File Size:||34.30 Mb|
|ePub File Size:||39.13 Mb|
Timing Belt Pulley Pitch Diameter & Outside Diameter Charts
Stock or standard positive drive belts will ride toward the left flange, as indicated in the image to the right. If only one flange is located on the pulley, it should be placed on the left.
A small amount of clearance should exist between the root section timing belt pulley catalogue the pulley teeth to prevent the belt from bottoming out.
Left Running Timing Belt Generally, positive drive belt pulleys are flanged to help keep the belt in position. This calculator computes belt lengths for various center distances and checks the number of teeth in mesh for both pulleys.
The correct fit for the pulley contact is shown.
TIMING PULLEYS & BELTS :: Capital Bearing Supplies Pty Ltd
A small amount of clearance should exist between the root section of the pulley teeth to prevent the belt from bottoming out. On long center drives, the belt may have a tendency to run to one side of the pulley.
Stock or standard positive drive belts will ride toward the left flange, timing belt pulley catalogue indicated in the image to the right. Specialised timing belt pulleys Besides standard belt pulleys, which we always stock, we also offer the option to have custom made timing belt pulleys milled or hobbed.
- Belcon Powertrans LLP
- OPTIBELT Timing Belt Pulley for taper bush section H cast iron
- TIMING PULLEYS & BELTS :: Capital Bearing Supplies Pty Ltd
- HTD Timing Belt
- Driven By Quality
- TIMING PULLEYS & BELTS